Designed
specifically for the efficient maceration of abrasive sludge,
the TR Muncher is very effective in capturing irregular shaped
objects. The layback cutter shafts on this Muncher
are set at an angle to the incoming flow. If a rejection
cycle is necessary, the object can drop into the built-in trash
trap set clear of and below the cutter stacks, preventing
damage. The trash trap is fitted with a large diameter
access port to enable easy removal, cleaning and flushing.
Capacity:
1,937 GPM
Differential Pressure: Up to 6 PSI
Features
& Benefits
Monoflo ETOS
cutters offer positive and effective solids grinding
Shafts
operate at differential speeds to promote a tearing action
on the solids
Pull back
cutter stack allows removal without disturbing the pipeline
Cantilever
shaft design eliminates the need for bottom bearings and
seals, significantly reducing wearing components
Patented
built-in trash trap with clean-out ports to catch any
rejected material
Low cutter
tip speeds, low power and low noise level
Each Muncher
is supplied with a programmable logic controller (PLC) to
protect the machine against damage and overloads
Munchers can
be supplied to comply with the ATEX Directive 94/9/EC
TR
Muncher Brochure
