Hydromatic Packaged Self Priming Lift Stations

The 6’X6’ above ground lift station is a pre-engineered, economical station shipped complete from the factory. Just connect the incoming power and piping connections to be on line. The low silhouette fiberglass station blends in with the surroundings. Since it is an all fiberglass enclosure, it will resist organic corrosion and is weather-tight. The four access panels, two lockable hinged and two with tamper-proof fasteners, provide easy access for routine maintenance. For added security, the station is designed to be vandal-resistant. The station will accommodate two 40RP, 4½ pumps with a maximum of 25 HP and flows from 70 to 600 GPM.

Mechanical
Standard equipped 6’X6’ above ground lift station includes the following mechanical components: Station is equipped with duplex “RP” sewage pumps, V-belt driven by 1750 r.p.m. open drip proof “T” frame motors, 25 horsepower maximum. Piping includes individual suction lines terminating at the 90¾ suction elbow, individual discharge swing check valves, a three way plug valve and individual air bleed lines with shut off valves. A thermostat controlled vent fan is furnished in the station roof.

Electrical
The standard station electrical components include the following devices: The motor control and liquid level controls are mounted in individual NEMA 3R steel enclosures. Features include: Thermal-magnetic motor branch circuit breaker, magnetic motor starters across the line start, with overload protection on all phases, corrosion inhibitor, pressure-activated liquid level control, high water alarm circuit, lead pump/lag pump alternator, fault indicators, elapsed time meters, pump run lights, high pump temperature shut down circuit, motor overload resetters, pump sequence selector switch, duplex GFI receptacle and UL approved controls.

Piping
Standard piping arrangements that are offered.
40RP Station, 4” pumps

Available Station Options:

• Automatic air release valve assembly

• Hand held station light

• Pump drain kit

• Pump spare parts kit

• Station heater 1300/1500 watts

• Suction & discharge gauges

• Volute casing heaters

Available Control Options:

• Air bubbler

• Alarm bell

• Alarm horn

• Alarm light

• Dry alarm contacts

• Lag pump delay circuit

• Low water alarm circuit

• Mercury float switch control non-intrinsically safe or intrinsically safe

• NEMA rated starters

• Panel heater

• Power “ON” indicating light

• Power transformer

• Three phase voltage monitor

• Transient voltage surge

SUPPORT DOCUMENTS PFC6x6 Brochure 1150 RPM Performance Curve 1750 RPM Performance Curve

RELATED LINKS Factory Website